Poweramp VS VERTICAL SPECIALTY 4.2009 User Manual download pdf (Page 10)

INSTALLATION

Prepare Pit

Before lowering the dock leveler into the pit, the

following must be performed:

1. Remove all debris from the pit and sweep the pit

clean.

2. Check the entire dock leveler pit for proper

construction according to approved/certified pit

drawings. Make sure pit is square, has the proper

depth and taper by making the following

measurements:

• Measure pit width distance (A) at both front

and rear of pit.

• Measure dock floor-to-pit floor distance (B) on

both sides of the rear embed channel and at

front if applicable.

• Measure pit floor taper, rear to front cannot

exceed 1/2” total taper.

• Measure pit length distance (C) at both sides.

• Measure corner-to-corner (criss-cross)

distance (D) at both sides. Take measurements

at dock floor level and at pit floor level.

NOTE” If any measurement is off by more than

1/8 in. (3.18 mm), contact Poweramp

Technical Services before proceeding.

3. Make sure the field junction box for the dock

leveler (E) and floor embed plate (F) is at the

correct location per pit diagrams.

A—Distance (Pit Width)

(Front and Rear)

B— Distance (Dock Floor-to-Pit

Floor) (All Four Corners)

1/2” Taper Rear to Front

C— Distance (Pit Length)

(Both Sides of Pit)

D— Distance (Pit Corner-to-Corner)

(Top, Bottom, and Both Sides)

4111-0008 — April 2008

Post safety warnings and barricade the work area

at dock level and ground level to prevent

unauthorized use of the dock leveler before

installation has been completed.

Failure to follow the installation instructions can

result in damage to dock leveler, the facilities,

and/or serious personal injury or death.

Only trained installation professionals with the

proper equipment should install this product.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comments to this Manuals

No comments

Poweramp VS VERTICAL SPECIALTY 4.2009 User Manual Page 10

Comments to this Manuals