Poweramp EH SERIES HYDRAULIC User Manual download pdf (Page 16)

4111-0004 —November 2003

Rev “B” February 2011

INSTALLATION

A— Front of Dock Pit

B— Dock Leveler Frame

C— Side Pit Curb Angle

D— Gap [3/4 in. (19 mm)

Minimum]

E— Pry Locations

F— Rear Hinge Frame Angle

G— Rear Pit Curb Angle

H— Flare Bevel Weld, Typical

(To Fit Spacing)

8. With rear hinge frame angle (F) tight against rear

pit curb angle (G), perform/check the following:

• Pry between the platform and rear hinge frame

angle at locations (E) to make sure rear edge

of platform is parallel to the rear hinge frame

angle (F).

• Gap (D) must exist equally along both sides of

leveler so weather seal (if equipped) will not

bind during dock leveler operation.

9. If gap (D) cannot be obtained equally at both

sides of leveler, grind or add material at the rear

edge of rear hinge frame angle (F) as needed.

10. Allow the dock leveler to rest fully on the shim

stacks. Check that a smooth and level transition

exists between the dock floor and the dock

leveler platform. Add or remove shims as

necessary until a smooth transition is obtained.

11. If leveler cannot be squared and/or made level

as instructed in steps 8 — 10, contact Poweramp

Technical Services.

6 in.

(152 mm)

3/8 in.

(9.5 mm)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

No comments

Poweramp EH SERIES HYDRAULIC User Manual Page 16