Poweramp EH SERIES HYDRAULIC User Manual download pdf (Page 24)

4111-0004 —November 2003

Rev “B” February 2011

OPERATION

End Loading/Unloading — Platform at Cross-Traffic Position.

End Loading/Unloading — Platform at Below-Dock Position.

5. If truck/trailer bed is below the dock floor level,

and the dock is equipped with the optional lip-out

button, perform steps 6 –12.

4. If truck/trailer bed is at or above dock floor level,

leave leveler at the cross-traffic position and

proceed with loading or unloading.

NOTE: If ramp loading is required, see Ramp

Loading/Unloading Instructions on page 19.

End loading or unloading can be done with

the dock at the cross-traffic position or

below-dock position, depending on the height

of the truck/trailer bed.

1. Check to make sure truck/trailer is positioned

squarely against dock bumpers.

2. Instruct driver to remain at the dock until the

loading or unloading process has been completed.

3. Chock the truck/trailer wheels or use the truck

restraint if available.

End Loading/Unloading Instructions

6. Turn the ARTD switch (A) on the control panel to

the OFF position, if equipped.

7. Push the Raise button (B) to the platform just

enough to clear the lip keepers.

8. When the platform lip clears the lip keepers, push

the Lip-Out button (C) just long enough to clear

the lip keepers. Release Lip-Out button. The

platform will drift down to the full below-dock

position.

9. Proceed with loading or unloading.

NOTE: When end unloading is finished and access

to the rest of the truck/trailer is still required,

the platform lip will need to be extended. See

Ramp Loading/Unloading Instructions on

page 19 for further instructions.

10. When the loading or unloading is finished, return

the dock leveler platform to the cross-traffic

(stored) position by performing one of the

following:

• Turn the ARTD switch (A) to the ON position, if

equipped. After approximately six seconds, the

platform will automatically rise to the cross-

traffic position.

• Push the Raise button (B) until the lip clears the

lip keepers. Release Raise button, leveler will

return to the stored or cross traffic position.

11. Remove chocks from truck/trailer wheels or

release the truck restraint if used.

12. Indicate to the driver that the truck may leave the

dock.

A—ARTD Switch

Operating Instructions—Continued

Whenever end loading or unloading with the

platform in the below-dock position, make sure the

ARTD switch is in the OFF position. DO NOT turn

the ARTD switch to the ON position until end

loading or unloading is finished.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Comments to this Manuals

No comments

Poweramp EH SERIES HYDRAULIC User Manual Page 24

Comments to this Manuals

Related products and manuals for Hoist Poweramp EH SERIES HYDRAULIC