Poweramp EH SERIES HYDRAULIC User Manual download pdf (Page 23)

4111-0004 —November 2003

Rev “B” February 2011

OPERATION

NOTE: If end unloading is required, see End

Loading/Unloading Instructions on page 24.

For ramp loading or unloading, the EH dock

leveler can be operated by using the RAISE

button on the control panel.

1. Check to make sure truck/trailer is positioned

squarely against dock bumpers.

2. Instruct driver to remain at the dock until the

loading or unloading process has been completed.

3. Chock the truck/trailer wheels or use the truck

restraint if available.

Ramp Loading/Unloading Instructions

4. Extend the platform lip onto truck/trailer as follows:

a. Raise the platform by pushing and holding

RAISE button .

b. Hold the RAISE button until the lip is fully

extended, then release the RAISE button. The

platform will lower until the lip is resting on the

truck/trailer bed.

c. Make sure that the lip is fully extended and

supported on the truck/trailer along the entire

width of the platform with at least 4 in. (102 mm)

of lip contacting the truck bed.

7. When loading or unloading is finished, raise the

platform by pushing and holding RAISE button

(A) .

Hold the RAISE button until the lip folds enough

to clear the truck/trailer bed, then release the

RAISE button. The lip will fold and the platform

will return to the cross-traffic position.

8. Remove chocks from truck/trailer wheels or

release the truck restraint if used.

9. Indicate to driver that truck may leave the dock.

A—RAISE Button

A—RAISE Button B—ARTD Switch

5. Proceed with loading or unloading the truck/trailer.

6. If end loading is necessary, see End

Loading/Unloading Instructions on page 20.

Operating Instructions—Continued

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

No comments

Poweramp EH SERIES HYDRAULIC User Manual Page 23